![]() ![]() To avoid it, modify the file +INSTALL file and find function checkarchcompatibility. You should be able to transfer file without any difficulties.Use scp command for secure transfer.Īs it is not such a option supported in FreeBSD, we have to prevent to check this parameter. ![]() ![]() Do not panic if you are not familiar with those strange network settings - in fact, there is NAT connection between the guest and host system. After boot, configure network settings as following:dhclient em0The command assigns an IP address 10.0.2.15/24 to the interface em0 and create a static route 0.0.0.0/0 to the default gateway 10.0.2.2. Start qemu disk and copy utility to the host.Here is the command we will use:/usr/local/bin/qemu-system-i386 -m 512 -boot c -net nic,macaddr=00:aa:00:60:01:01,model=e1000 -hda olive-base.img -enable-kvm -net userThe command tells Qemu to start Qemu disk with single network e1000 interface. We have to replace this binary with utility /usr/bin/true located in FreeBSD. Then we can pack archive back and copy it to the guest.Here are the steps:a) Copy true utility from FreeBSD to the hostCheckpic is binary that is stored in the installation archive. It is much faster than to do the same in FreeBSD. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |